How to restore wooden floors?

Start your hardwood floor renovation project by preparing the room. To do this, remove all objects from the room you plan to work in. This includes furniture, rugs, decorative objects, accessories, costa rica phone number library etc. Anything left inside will be exposed to a large amount of dust and debris that will be produced during sanding.

It’s also a good idea to keep the room closed as much as possible to prevent dust from spreading throughout the home. Cover doors, vents, and electrical outlets with plastic sheeting and use tape to secure them. Open windows to ventilate and remove some of the dust and debris that may be in the air.

Check the floor for nails or, if you’ve lifted the carpet, anything else that may have been left behind. Sharp objects like these can destroy the sandpaper on your sander, forcing you to replace it and making the job longer than necessary. Using a hammer, tap any nails you find as deep as possible into the floor’s surface.

Remember that your floor surface will be slightly lower than it was after sanding. Sweep and mop the floor thoroughly before starting work.

2. Use a floor sander

Get an electric floor sander. need refinishing approximately every 10 years, so you don’t need to buy one if you don’t want to; you can always rent one. These devices strip the wood of its old finish and smooth the surface for the new finish.

Make sure you follow the instructions and understand how they work before you begin. Read all instructions carefully to ensure you know how to use the machine. If necessary, the selection was officially launched request a demonstration at your place of purchase or rental. 

You might be interested in: 8 tips to clean your home faster

3. Start sanding

Place a coarse-grit sandpaper on the sander and begin sanding the floor slowly and evenly, following the wood grain. Move the sander in straight, even motions. 

Start in the very center of the room and work your way across the middle of the floor, leaving a couple of inches between each stroke. Always remember to keep the sander moving when it’s on. Repeat the wood floor sanding processon the other half of the room.

Gradually, you’ll start getting too close to the walls and risk hitting the baseboards and damaging them. When this happens, bgb directory you can put down the sander and use a handheld sander to finish sanding the rest of the floor near the walls.

Make sure you use the same type of sandpaper you used with the large sander. After polishing with the coarse-grit sheet, vacuum up the dust. Switch to the medium-grit sheet and repeat the same sanding procedure. 

Don’t forget to also sand the edges along the walls with medium-grit sandpaper. Vacuum up the dust, change to fine-grit sandpaper, and repeat the process. Sanding with each grit ensures a better result. Wipe the dust off all surfaces and finish with a soft cloth. 

4. Apply the varnish

To apply varnish to a wood floor, carefully follow the package’s instructions for preparation and application. This is usually done on clean wood using a roller. 

Start at the far corner of the door and apply the varnish smoothly and evenly, following the direction of the wood. Work your way back toward the door until you’ve covered every inch of the floor. Keep a small, angled-bristled brush handy for areas you can’t reach with the roller.

Now you know four tips for refinishing wood floors . Remember to clear the areas where you’ll be working, use a sander appropriate for the type of floor, and apply the varnish correctly. By following these tips, your floor will look like new. We hope this information has been very useful. 

Edifica Real Estate has 15 years of experience developing projects in the most established districts of Lima and other cities. You’ll find the best apartments and offices. If you’d like more information about our projects, please contact us, and we’ll get back to you shortly .